CAT-6 Shielded Crossover Ethernet Patch Cable, Half-Moon, Booted, Gray with Green Boots, 25'

This 25 ft Cat6 shielded crossover patch cable connects two like devices directly, such as switch to switch, PC to PC, or router to router, without a hub or switch in between. It's wired T568A on one end and T568B on the other, the standard crossover configuration, so the transmit and receive pairs are swapped for a direct device-to-device link. The shielded construction protects against electromagnetic and radio frequency interference (EMI/RFI), making the cable well suited to industrial floors, warehouses, data centers, and other environments with heavy electrical equipment. Built to Cat6 standards, it supports Gigabit Ethernet and up to 10 Gigabit over short distances, with bandwidth up to 250 MHz. Each end has a shielded RJ45 male connector protected by a molded half-moon boot, which provides strain relief and keeps the latch from snagging during installation. The green boots against the gray jacket make crossover cables easy to tell apart from standard patch cables in racks and panels, which helps prevent connection errors during setup and troubleshooting. The 24 AWG stranded bare copper conductors keep the cable flexible for patching while maintaining reliable signal performance. Specifications: Cat6 shielded crossover, 25 ft length, gray jacket, green half-moon molded boots, RJ45 male to RJ45 male, 24 AWG stranded bare copper, 250 MHz, PVC (CM) jacket. The long description treats the earlier estimates (24 AWG, 250 MHz, stranded copper, PVC jacket, T568A/T568B wiring) as facts. Verify them against the supplier's spec sheet before publishing, and adjust if it lists different values, such as 550 MHz.